# Crossover - Turntable Through the Mother-32 Ladder - SignalPath
Patch: [[Patches/Crossover/Crossover - Turntable Through the Mother-32 Ladder]]
Build: [[Patches/Crossover/Crossover - Turntable Through the Mother-32 Ladder - Build|Build]]
## Overview
The record comes in through the Phono Preamp, the Mother-32 ladder and VCA chop it on a Labyrinth rhythm, the left side gets echo, and the right side is the same filter, ungated. Phono Preamp MONO and Echo jack silk-screens are check panel.
```mermaid
flowchart LR
TT[Turntable] --> PP[Phono Preamp]
PP --> M32[Mother-32 ladder]
Lab[Labyrinth] -- "SEQ1 trig" --> M32
Lab -- "SEQ2 CV" --> M32
M32 -- "VCA gated" --> E[Echo]
E --> O[A-541 line out]
M32 -- "VCF ungated" --> O
linkStyle 0 stroke:#222,stroke-width:3px
linkStyle 1 stroke:#e0b800,stroke-width:3px
linkStyle 2 stroke:#d62828,stroke-width:3px
linkStyle 3 stroke:#1e63d6,stroke-width:3px
linkStyle 4 stroke:#e0b800,stroke-width:3px
linkStyle 5 stroke:#e0b800,stroke-width:3px
linkStyle 6 stroke:#e0b800,stroke-width:3px
```
**Cable colors:** [[Cable Colors]] after [Learning Modular](https://learningmodular.com/choosing-patch-cables/): ⚪ Gray 1 V/oct · 🔵 Blue modulation · 🟡 Yellow audio · 🔴 Red gates/triggers · 🟢 Green clock/sync · ⚫ Black external
## Why it sounds like resonant gated stabs
The Phono Preamp's MONO output, at modular level, goes to Mother-32 EXT. AUDIO, with MIX fully toward EXT. VCA MODE is EG, attack fully down, decay just before noon, sustain off. Labyrinth SEQ1 TRIG, 0 to 5 V, gates each stab, with about 5 bits on for the chop rhythm. SEQ2 CV jumps the cutoff, and resonance at 2 o'clock lets the filter ring on each jump. Labyrinth's own volume stays down.
## Why left and right differ
The Mother-32 VCA output is the gated signal, and that goes through the Echo to the A-541's left channel, so the left side has an echo trail. The Mother-32 VCF output is the same record through the same filter, but not gated, and that goes dry to the right channel as a continuous wash.
## Why the preamp matters
EXT. AUDIO is a unity-gain input built for 10 V peak-to-peak, and the Mother-32 manual warns that line-level sources come in weak. The Phono Preamp's modular-level output is what you want, so do not skip it and plug a line source straight in. The cases run on separate supplies. If you get hum when you join them, look at grounding before blaming the patch.
## Short version
The record is the source, Labyrinth is the knife, and the Mother-32 is the filter that rings when it's cut.